How do you use a vacuum packing machine? Here we will show you the detailed operate steps:
After the vacuum packing machine is turned on, the time and status display shows the standby status.
1. Pumping time setting: In the non-running state, press the pumping time setting key once, the corresponding indicator light flashes, and the display shows the original setting value. At this time, you can use the increase or decrease key to set the time required, and again Press this key to return to standby. In the non-operation state, the extraction time setting key and heat sealing time setting key can be switched freely.
2. Heat sealing time setting: In the non-operation state, press the heat sealing setting key once, the corresponding indicator light flashes, and the display shows the original setting value. At this time, you can set the time required by the increase or decrease key Press the key again to return to standby.
3. Heat-seal temperature range setting: Press the heat-seal temperature setting key to set the heat-seal temperature range, followed by low temperature, medium temperature, high temperature, and turn off heating.
In the standby state, when the lid is closed, the machine enters the packaging process. The procedure is as follows:
a) Pumping down: The pumping down program starts, the timer counts down from the set value, the display shows the countdown time, the program ends when the counting time reaches zero, and the next program is performed.
b) Heat sealing: The heat sealing work program starts. The timer starts counting from 0.0 seconds. The display shows the time counting to the set time.
c) Insulation: The incubation time is fixed at 2 seconds. During the deflation process, the display shows the set value of the heat seal time.
d) Deflation: The deflation time is fixed at 2 seconds. During the deflation process, the display shows the symbol "口口". After the end of the deflation process, the vacuum cover is opened and the machine returns to the standby state.
If you have any questions about the whole process, please contact us: